The idea in one paragraph
A pre-engineered building (PEB) is designed as a complete system: the main frames, the secondary members, the bracing and the roof and wall cladding are sized together by the supplier for the loads, spans and heights of one project. Every member is cut, welded, punched and painted in the factory, so on site the crew only bolts the pieces together. Compared with a conventional steel structure built from standard hot-rolled sections, a PEB usually uses less steel because each member is shaped to follow the forces acting on it.
The main components
| Component | What it is | Typical form |
|---|---|---|
| Primary frame | Columns and rafters forming portal frames, usually at 6–9 m spacing | Built-up I-sections welded from plate, often tapered (deeper where the bending moment is largest) |
| Secondary members | Purlins (roof) and girts (walls) that carry the cladding to the frames | Cold-formed C or Z sections, galvanised; Z sections can be lapped over the frames for continuity |
| Bracing | Rod, angle or cable bracing in roof and walls; flange braces that restrain the inner flange of rafters and columns | Round bars with turnbuckles, angles, pipes |
| Connections | End plates bolted with high-strength bolts; base plates on anchor bolts | Plates welded to the members, punched or drilled holes |
| Cladding & accessories | Roof and wall sheeting, insulation, gutters, downpipes, skylights, ventilators, doors | Profiled coated steel sheet, sandwich panels |
| Ancillary structures | Mezzanines, crane beams, canopies, fascias, partitions | Hot-rolled or built-up sections |
Why owners choose PEB
- Speed: design, fabrication and foundations run in parallel; erection is bolting only.
- Economy: tapered built-up members put steel where it is needed; long clear spans without internal columns.
- Predictable quality: welding and coating happen under factory conditions, to a written procedure.
- Flexibility: buildings can be extended by adding bays at the end wall.
What it means for the fabricator
A PEB project contains a few hundred heavy built-up members and thousands of light parts – purlins, girts, bracing rods, clips, bolts. They follow very different routes through the shop: plate cutting, web-to-flange welding and end-plate fitting for the frames; roll-forming and punching for purlins; buying-in for bolts and sheeting. Getting every piece to the right container and the right grid line on site is as important as fabricating it.
Vedi anche
Aggiornato il 01 Nov 2026